Developing custom built actuators for all industries. Specializing in prototypes.
We start by learning exactly what your actuator needs to do—stroke length, force, environment, mounting, and anything else that matters. Then we design a solution that fits.
Once the design is mapped out, we send over a quote that includes drawing and an estimated timeline. No surprises—just what it’ll take to get it done right.
You’ll review the design, drawing/BOM. If something needs to change, we tweak it. Once it’s approved, we’re ready to build.
Our team gather the parts, machines and assembles everything in-house. Each actuator is tested to make sure it hits the specs before we send it your way.
If you have a question regarding this process or our actuators, please don’t hesitate send us a note using the form below someone will respond in a timely manner.
Depending on the gear ratio, up to 3,500 pounds.
We have standard lengths of 4, 6, 8, 12, 18, 24, 36, & 48
We can make any other length up to 72 inches.
Depending on the gear ratio & load, .15 inches per second to 1.1 inches per second.
20% depending on conditions.
Yes, this is our specialty.
